Area overview
Start here
Vehicles use a mix of networks, each chosen for cost, bandwidth and determinism:
| Technology | Typical rate | Typical use |
|---|---|---|
| LIN | ≤ 20 kbit/s | Simple sensors and actuators (switches, mirrors, seats) |
| CAN / CAN FD | 0.5 / up to ~5–8 Mbit/s | Control and powertrain signals, J1939 in trucks |
| CAN XL | ~10–20 Mbit/s | Larger payloads, IP tunnelling, a bridge between CAN and Ethernet |
| 10BASE-T1S | 10 Mbit/s, multidrop | Zonal edge nodes; “Ethernet all the way to the sensor” |
| 100/1000BASE-T1 | 100 Mbit/s – 1 Gbit/s | Backbone, cameras, HPC links |
| Multi-gig (MGBASE-T1) | 2.5–10 Gbit/s | Sensor fusion, central compute backbone |
Ethernet backbone and TSN
Zonal architectures run an Ethernet backbone between zone controllers and central compute. Time-Sensitive Networking (TSN) makes it deterministic enough for control traffic: time synchronisation (IEEE 802.1AS / gPTP), credit-based and time-aware shaping, frame preemption and redundancy. IEEE 802.1DG-2025 selects which TSN features and defaults automotive networks should use.
10BASE-T1S uses PLCA (Physical Layer Collision Avoidance), a round-robin scheme that gives deterministic access on a shared single-pair bus — CAN-like wiring, Ethernet addressing.
How it fits together
Signals from sensors enter at the zone controller (CAN, LIN or 10BASE-T1S), are packed into Ethernet frames and carried over the backbone to central compute, where services consume them via SOME/IP or DDS. Security (SecOC, MACsec) and network management (sleep/wake) apply on every segment.
State of play (late 2026)
- Production silicon exists for both new technologies: 10BASE-T1S transceivers (e.g. NXP TJA1410) and CAN XL transceivers are released for automotive programmes; vendors position them as complementary rather than competing.
- 802.1DG was published in June 2025; an amendment for an automotive time-synchronisation profile is in drafting.
Commercial-vehicle angle
Trucks rely heavily on SAE J1939 over CAN, plus trailer (ISO 11992) and body-builder interfaces. Long frames and many variants make cable length and harness weight important — and legacy ecosystems must be supported for years after an Ethernet backbone arrives.
Key sources & further reading
- IEEE 802.1DG-2025 — automotive TSN profile project page.
- Ashjaei et al., Time-Sensitive Networking in automotive embedded systems: State of the art and research opportunities, Journal of Systems Architecture, 2021 (DOI).
- Lo Bello, Patti & Leonardi, A Perspective on Ethernet in Automotive Communications — Current Status and Future Trends, Applied Sciences, 2023 (open access).
- Seol et al., Timely Survey of Time-Sensitive Networking: Past and Future Directions, IEEE Access, 2021.
- CAN in Automation (CiA) — CAN XL specifications, CAN Newsletter and the iCC proceedings.